Introduction
US carriers pay intermediaries an extra 15–40% on every minute of voice traffic because their termination provider isn’t actually the one routing the call. MeraTalk is a wholesale VoIP termination provider in the USA that owns the route — no resold minutes, no hidden markup, and a full FCC paper trail to prove it.
We terminate A-Z voice traffic for carriers, resellers, call centers, and UCaaS platforms out of a US-licensed network registered with the FCC under both Section 214 (international) and Section 499 (domestic), plus active filing in the Robocall Mitigation Database. If your current provider can’t say the same in one sentence, keep reading.
Key Takeaways
- Direct-route wholesale VoIP termination — no middleman, no unknown hops
- FCC 214 + 499 licensed and RMD-registered, with full STIR/SHAKEN attestation
- 99.99% SLA-backed uptime across geo-redundant US points of presence
- Per-second billing, transparent A-Z rate decks, and no minimum commitment to start
- 24/7 NOC with US-based engineers — not a ticket queue, a phone number
What Makes MeraTalk Different From Other Wholesale VoIP Termination Providers
Most wholesale voice providers in this market resell Tier-2 or Tier-3 minutes from a handful of upstream carriers. That’s fine — until a route goes red at 2 a.m. and your provider is calling their provider to figure out what happened. MeraTalk cuts that chain.
Here is what we put in writing:
| Capability | MeraTalk | Typical Reseller |
|---|---|---|
| FCC Section 214 (international) | Yes — filed and active | Rarely licensed directly |
| FCC Section 499 (domestic USF) | Yes — filed and active | Often missing |
| Robocall Mitigation Database | Registered with full STIR/SHAKEN attestation A | Partial or B/C attestation |
| Uptime SLA | 99.99% with service credits | “Best effort” |
| Route control | Direct interconnects to Tier-1 US carriers | Pass-through reseller |
| Billing transparency | Per-second, live CDRs, published rate deck | 6-second minimum, monthly invoice only |
If you’re reselling voice yourself, those six rows are the difference between a clean compliance audit and a FCC complaint letter. Post-June 2025, the FCC started enforcing STIR/SHAKEN on gateway providers aggressively — partners who terminate through non-attested routes are the ones absorbing the risk.
Wholesale VoIP Termination Rates You Can Actually Read
One of the most common complaints we hear from carriers switching to us is the same sentence: “I never knew what I was actually paying per minute.” That’s by design in this industry — most rate decks hide CC (Call Center) surcharges, A-number screening fees, and market destination premiums inside a single blended rate.
MeraTalk publishes a full A-Z deck with three clearly labeled route types:
- CLI (Clean Line Identification): Caller ID intact end-to-end. Required for regulated markets and CC clients.
- Non-CLI: Cost-optimized routing where caller ID pass-through isn’t required. Lower rates, same voice quality.
- CC (Call Center) Grade: Tuned for high concurrency and short AHT — low ASR-adjusted pricing, low PDD, FAS-monitored.
No rate drift. No silent downgrades from CLI to Non-CLI mid-month. If a destination’s cost changes, you get 30-day notice.
Built for US Carriers, Resellers, and Call Centers
MeraTalk’s wholesale VoIP termination network is engineered around the traffic profiles of four customer types:
1. Regional CLECs and ITSPs
You need diverse PSTN termination, LNP support, and clean E911 pass-through for your retail subscribers. MeraTalk plugs into your existing SBC (Metaswitch, Ribbon, AudioCodes, Cisco, or open-source FreeSWITCH/Kamailio) over SIP with TLS and SRTP.
2. VoIP Resellers
You sell minutes to business customers and your margin lives or dies on termination cost and CDR accuracy. We issue white-label rate decks, per-sub-account CDRs, and a partner portal for real-time balance checks — so your billing system can automate margin reconciliation.
3. Contact Centers
Outbound dialing needs PDD under 3 seconds, ASR that reflects actual answered calls (not FAS), and caller ID that doesn’t get flagged as spam on Day 3. Our STIR/SHAKEN A-attestation signing plus RMD registration is the reason our contact center clients see flagging rates 4–6× lower than what they had on reseller routes.
4. UCaaS and CPaaS Platforms
You’ve built the app — you need the PSTN layer. MeraTalk acts as the voice termination backbone for platforms that want a single US-compliant upstream without building their own carrier relationships.
99.99% Uptime Is a Math Claim, Not a Marketing One
99.99% uptime works out to 52 minutes of permitted downtime per year. That’s the number in our SLA — and if we miss it, customers get service credits automatically applied the following invoice cycle.
Three things make that number real:
- Geo-redundant POPs across multiple US metros, with active-active session replication so a single-site failure doesn’t drop calls in progress.
- Carrier diversity — every destination has a minimum of three upstream routes, with automatic least-cost / best-quality rerouting if one degrades.
- 24/7 US NOC staffed by engineers, not first-line readers. You get a direct number, not a portal ticket form, for P1 incidents.
We publish our historical uptime on the MeraTalk status page. It’s checkable, not pitchable.
STIR/SHAKEN and the Compliance Layer
The FCC’s Second TRACED Act enforcement means that by 2026, every call originating or terminating in the US needs to either carry a valid STIR/SHAKEN attestation or be blocked by downstream providers. A lot of wholesale voice providers are still figuring out what that means for their network.
MeraTalk’s position:
- We sign all eligible outbound calls with STIR/SHAKEN A-level attestation (full authentication of calling party).
- We’re registered in the FCC Robocall Mitigation Database — required for US termination since 2021.
- We provide partners with attestation-signed CDRs so your own compliance reporting has a verifiable source of truth.
If your current provider can’t tell you their RMD registration number, that’s a red flag worth chasing this week.
Voice Products Beyond Termination
Carriers moving termination to MeraTalk typically consolidate the rest of their voice stack with us over the following 3–6 months. The surface area:
| Product | Use Case |
|---|---|
| Wholesale VoIP Termination (A-Z) | Outbound PSTN termination, 220+ countries |
| DID Origination | Local and national US numbers in all 50 states, instant activation |
| Toll-Free Origination | 800 / 888 / 877 / 866 / 855 / 844 / 833 numbers with responsible organization (RespOrg) support |
| SIP Trunking | Direct SIP trunks for PBX / UCaaS / contact center platforms |
| Number Porting (LNP) | Full US LNP support with transparent port status |
| A2P SMS / Short Code | 10DLC-compliant messaging for businesses with high-volume SMS needs |
How to Start With MeraTalk
Onboarding a new wholesale VoIP termination provider usually takes weeks in this industry. We’ve compressed it to three steps:
- Test account in 24 hours. Share your estimated traffic and target destinations. We issue a test SIP endpoint, a rate quote, and a prepaid balance so you can run live traffic before committing.
- Rate negotiation. Once your traffic pattern is visible on live CDRs (usually 5–7 days), we tune the rate deck to your actual destination mix.
- Production migration. Signed MSA, monthly billing terms, direct NOC access, and a named account engineer.
No setup fee. No minimum spend to start a test account.
Frequently Asked Questions
What is a wholesale VoIP termination provider?
A wholesale VoIP termination provider routes outbound voice calls from a business, carrier, or platform to the destination PSTN (public switched telephone network) — effectively delivering the call to whoever’s on the other end. “Wholesale” means the provider sells minutes in bulk to other carriers, resellers, or platforms rather than to end consumers.
How is MeraTalk different from other wholesale VoIP termination providers?
Three things: we hold both FCC 214 and 499 licenses directly (most competitors resell from someone who does), our network is registered in the Robocall Mitigation Database with full STIR/SHAKEN A-attestation, and our rate deck is per-second with published CLI / Non-CLI / CC rates — no blended opacity.
What’s the minimum commitment to start with MeraTalk?
Zero. We open a prepaid test account so you can run live traffic on a sample destination list before signing anything. Most customers move to a post-paid MSA within 2–3 weeks of testing.
Do you support LNP and porting existing numbers?
Yes. We handle local number portability for all 50 US states, including toll-free numbers with RespOrg transfers. Port status is visible in the partner portal in real time.
What uptime do you actually deliver?
Our contractual SLA is 99.99%, backed by service credits. Our trailing 12-month measured uptime is published on the MeraTalk status page. If we miss the SLA in any month, credits are applied automatically on the next invoice.
How fast can I get a wholesale termination rate quote?
Within one business day if you share your top 10–15 destinations and approximate monthly minutes. Full A-Z custom pricing takes 2–3 days because we route it through the actual NOC team, not a sales template.
Talk to a MeraTalk Engineer About Your Routes
If you’re evaluating a new wholesale VoIP termination provider, the fastest way to decide is to run real traffic. Send us your destination mix and we’ll reply in 24 hours with a rate quote, a test SIP endpoint, and a prepaid balance to validate voice quality before you commit.
MeraTalk is a US-licensed wholesale voice carrier. Learn more about our wholesale VoIP termination approach, how VoIP resellers partner with us, or read our guide on comparing wholesale VoIP termination rates.
